ST-HDoC / ST-HDoC-MM
19
Depending on the type of camera connected to the ST-HDoC, the Video “Format ” will automatically
switch between NTSC and PAL, and the Video Level will automatically switch between IRE (Institute
of Radio Engineers) and mV. NTSC signals measured in IRE units, PAL signals are measured in mV.
3.3.5 PTZ address search
Press
to select
then press
to enter.
Note
：
Please isolate the PTZ camera from other PTZ cameras before searching. Otherwise all
the PTZ cameras in the same system will be programmed at the same time.
Press
to select
, and then press
to enter device settings. Select “Address search”,
press
to select ON or OFF, then Press
to save. The PTZ address search function
will now display on the main menu.
（
Note
：
When the ST-HDoC is turned off, the Address search is defaulted to OFF
）
Press the
key to set: protocol and baud rate (be sure to match the PTZ camera settings)
Press the
button, and the tester will search for the ID quickly and continuously. When the ID is
found, the PTZ camera will pan right. At this time, please press
to stop searching.
