32
Enable
ARP/Ping set
device IP
address service.
You can use ARP/Ping command to modify or set the device IP
address if you know the device MAC address.
Before the operation, please make sure the speed dome and
the PC in the same LAN. This function is on by default.
You can refer to the steps listed below.
Step 1
: Get an IP address. Set the speed dome and the PC in
the same LAN.
Step 2
: Get the physical address from the label of the speed
dome.
Step 3
: Go to the Run interface and then input the following
commands.
arp –s <IP Address> <MAC>
ping –l 480 –t <IP Address>
Such as
：
arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
Step 4
: Reboot the device.
Step 5
: You can see the setup is OK if you can see there are
output information such as
“
Reply from 192.168.0.125 …
” from
the command output lines. Now you can close the command
line.
Step 6
: Open the browse and then input
http://<IP addres>
.
Click the Enter button, you can access now.
3.2.2 Connection
The connection interface is shown as in Figure 3-18.
Figure 3-18
