69
Please refer to the following sheet for detailed information.
Parameter Function
Protocol
Select the corresponding dome protocol.
2.6.3.2 Analog PTZ Setting
The analog PTZ setting interface is shown as in Figure 2-59.
Figure 2-59
Please refer to the following sheet for detailed information.
Parameter Function
Address
Set the software address you can control the device via the RS485
BUS. Default value is 1.
Baud
Rate
Set the baud rate you can control the device via the RS485 BUS.
Default setup is 9600.
Data Bit
Display data bit value.
Stop bit
Display stop bit value.
Parity
Set the parity you can control the device via the RS485 BUS.
2.6.4 Default
The default setup interface is shown as in Figure 2-60.
Please note system can not restore some information such as network IP address.
