Radio Key
®
600e
Operating & Installation
Secura Key
4
(Password)
(ENTER)
Presenting these cards to the RK-600e is equivalent to pressing keys on
a Keypad or key board. As you present program cards to the unit, it will
chirp to indicate that it has read the card. The next sections of this manual
explain what program card sequences to use to perform the various program
functions.
PROGRAMMING STEPS
To program the Radio Key
®
600e, you must first enter the program mode as
described in the next section below. Once in the program mode, the LED
will blink amber as an indicator. The unit will remain in the program mode
until it is put into another mode. Also, if a program card is not presented for
15 seconds, the unit will return to the active mode.
After you have completed a proper program sequence, the unit will beep
and the LED will flash green to indicate that the program instruction has
been accepted. A red light and three beeps at the end of a programming
sequence means that you have made an error. Refer to the appropriate
section, and carefully re-enter the command in the proper sequence.
If you select a User Number for a new Transponder, and a Transponder ID
Number has already been stored in memory for that User Number, a red light and
three beeps will occur. Select another User Number or void
the User Number,
which removes the previously stored Transponder ID from memory.
NOTE: User Number and ID Number Values in the
following examples are for demonstration
purposes only; enter the appropriate values
for your system.
To Enter Program Mode:
Present Program cards to the unit in the sequence that represents the
password and then present the “ENTER” card. (All new units are pre-
programmed with the password 12345.) The LED will flash amber to show
that the unit is in Program Mode.
The unit will “time out” and return to Active
(Normal) Mode in 15 seconds if no Program card is presented.
1 + 2 + 3 + 4 + 5 +
