21
ENFORCER Vandal Resistant Flush-Mount Access Control Keypad
SECO-LARM U.S.A., Inc.
Programming the Real-Time Clock:
A 24-hour real-time clock provides the baseline time needed to start and stop the output #1 auto-
disable time (see “Programming the Output #1 Auto-Disable Time” on pages 22-23).
If the output #1 auto-disable time is not programmed, it is not necessary to set the real-time clock.
To set the clock, use this general formula:
55 HHMM #
55
– Program Real-Time Clock
HH
– Hours
MM
– Minutes
Setting Hours and Minutes:
•
HH
represents hours and
MM
represents minutes in the military (24-hour) time format,
from 00:00 to 23:59.
Examples:
1.
Set the real-time clock to 11:30 AM:
55 1130 #
2.
Set the real-time clock to 7:15 PM:
55 1915 #
NOTE
:
•
If the output #1 auto-disable time is programmed, losing power will cause the keypad to beep 3
times every 5 seconds. To deactivate this alert, either reset the real-time clock or clear the output
#1 auto-disable time.
•
If the output #1 auto-disable time is not programmed, losing power will not cause the keypad to beep.
•
To ensure accurate time, it is advised to re-program the real-time clock every three to six months and
when Daylight Savings Time begins and ends (if applicable).
