Document number: SG104148TEN
Revision: B01
Issue date: 20.8.2012
Copyright© 2012 Sécheron SA - This document is not contractual and contains information corresponding to the level of technology at the date of release.
File: c-UR46-8S_inst_en.fm
C-21
UR46-81/82S
Installation
C.5
Packing
Always pack the circuit-breaker assembled with the arc chute and protected against impacts and
moisture.
C.6
Storage
Store the circuit-breaker in a dry (maximum 50% of relative humidity at 40°C), clean and covered
place, with a temperature range between -25°C and +55°C.
C.7
Disposal
If the device is to be permanently disposed of, disassemble it as far as possible and separate the
following materials:
– stainless steel
– copper and copper alloys
– aluminium
– rubber (seals, etc.)
– plastics
– electrical cables
– permanent magnets
Recycle or dispose of all materials and components in compliance with local regulations.
C.8
Tightening torques
C.8.1
General procedure
Each screw/nut needs to be tightened to a specific torque. Torques that are different from the
table below are indicated throughout this manual in their corresponding sections.
Put a new elastic washer each time one has been loosened.
For the purpose of checking the tightening of all screws and nuts, paint
a red line (1) from the screw/nut (2) onto the parts (3) after having tight-
ened any screw/nut to the requested torque.
C.8.2
Standard tightening torques
Unless specially indicated, use these values for greased stainless steel bolts.
Thread diameter
M3
M4
M5
M6
M8
M10
M12
Torque [Nm] ± 10% for A2/A4-70
1
1.7
3.4
5.9
14.5
30
50
Torque [Nm] ± 10% for A2/A4-80
1.3
2.3
4.6
8.0
19.3
39.4
67
1
3
2
Summary of Contents for UR46-81S
Page 68: ...Secheron ...