IMAQ
™
, National Instruments
™
, and ni.com
™
are trademarks of National Instruments Corporation. Product and company names mentioned herein
are trademarks or trade names of their respective companies.
3
7
2734A-01
©
Copyright 2000 National Instruments Corp. All rights reserved. October 2000
INSTALLATION GUIDE
IMAQ 6822 BNC B
REAKOUT
B
OX
This guide describes how to connect and use your IMAQ 6822 BNC
Breakout Box with your IMAQ hardware and analog cameras.
You can use the IMAQ 6822 BNC Breakout Box for single or
multiple-camera systems. Refer to your IMAQ hardware documentation
for detailed information on signal configuration.
What You Need to Get Started
To use your IMAQ 6822 BNC Breakout Box, you will need the following:
❑
IMAQ 6822 BNC Breakout Box and cable
❑
Your IMAQ device and documentation
❑
Your computer
❑
Your analog camera or peripheral devices and documentation
❑
BNC cables
Installation
Follow these steps to connect your IMAQ 6822 BNC Breakout Box to your
IMAQ device and camera(s):
1.
Install your NI-IMAQ driver software and IMAQ device. See your
hardware documentation for installation instructions.
2.
Insert the 68-pin VHDCI connector end of the cable that you received
with your breakout box into the receptacle of your IMAQ device,
ensuring correct polarity. Tighten thumbscrews as necessary.
3.
Insert the SCSI-type connector of the cable into your IMAQ 6822 BNC
Breakout Box receptacle, verifying polarity. Ensure that connector is
fully seated and that connector latches have snapped securely.
