Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 242 / 284

Advice
Note
For LED pilots, you can only change the fog or
reverse bulb, on the left or right guide.
Fitting the bulb holder
–
Install the bulb holder making sure that
locking clips
›››
Fig. 221
A
are properly
clipped on.
–
Replace the cover of the rear lid lining
›››
Fig. 220 .
Changing number plate light bulbs
Fig. 223
In the rear bumper: number plate
light.
Fig. 224
Number plate light: Remove the bulb
holder.
Follow the steps indicated:
1. Press the number plate light in the direc-
tion of the arrow
›››
Fig. 223 .
2. Remove the number plate bulb slightly.
3. In the connector lock, turn
›››
Fig. 224 to-
wards the arrow
1
and pull the connec-
tor.
4. Rotate the bulb holder in the direction of
arrow
2
and extract it with the bulb.
5. Replace the defective bulb with a new
bulb with the same features.
6. Insert the bulb holder in the number plate
light and turn in the opposite direction of
arrow
2
until it stops.
7. Plug the connector into the bulb holder.
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
have an estimated life that exceeds than that
of the car. If a light with LEDs fails, go to an
authorised workshop for replacement.
240