Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 170 / 284

Operation
Operating mode
Fig. 164
In the windscreen: field of vision of
the Lane Assist system camera.
Using the camera located in the windscreen,
the Lane Assist system detects the possible
lines dividing the lanes. When the vehicle in-
voluntarily approaches a dividing line it has
detected, the system notifies the driver with
a corrective steering movement. This move-
ment can be over-regulated at any time.
No warning is produced with the turn signals
activated, given that the Lane Assist system
understands that a lane change is required.
Steering wheel vibration
The following situations cause vibration in
the steering wheel and require the driver to
take active control of driving:
● When the limits of the very nature of the
system are reached.
● When the maximum rotational torque dur-
ing the corrective steering movement is not
enough to keep the vehicle inside the lane.
● When no lane is detected during the correc-
tive steering movement.
Switching the Lane Assist system on or off
Through the Easy Connect system
● Push the Easy Connect button
CAR
●
Push the
Setup
function button
● Press the function button
driver assistance
to
open the menu.
Alternatively: through the driving assist but-
ton on the turn signal level*.
The
Lane centring guide
is activated/deactiva-
ted in the Easy Connect system using the
CAR
button and the button on the
Setup
function
›››
page 81 .
Self-deactivation:
the Lane Assist system can
be automatically deactivated if there is a sys-
tem malfunction. The control lamp disap-
pears.
Hands-Off Function
● If the driver does not exert any physical ac-
tion on the steering wheel for approximately
10 to 12 sec. the function deactivates.
● Visual and audible warnings on the instru-
ment panel.
● The function switches off 2 seconds after
the warning.
The lane assist system is active but it is not
available (the control lamp is lit up yellow)
● When driving at speeds below 65 km/h (38
mph).
● When the Lane Assist system does not de-
tect the dividing lines of the road. For exam-
ple, in the event warnings indicating road
works, and snow, dirt, moisture or reflec-
tions.
● When the radius of a curve is too small.
● When no road markings can be seen.
●
When the distance to the next marking to
too great.
●
When the system does not detect any clear
and active steering movement during a long
period of time.
● Temporarily, in the event of very dynamic
driving styles.
● If a turn signal is activated.
●
With the stability control system (ESC) in
Sport mode or switched off.
Note
● Before starting a journey, verify that the
field of vision of the camera is not covered
›››
Fig. 164 .
●
Always keep the field of vision of the cam-
era clean.
168