Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 79 / 284

Driver information system
Menu Function
Operating
range
a)
Approximate distance in km that can
still be travelled with the fuel remain-
ing in the tank, assuming the same
style of driving is maintained. This is
calculated using the current fuel con-
sumption.
Journey dura-
tion
This indicates the hours (h) and mi-
nutes (min) since the ignition was
switched on.
Distance cov-
ered Distance covered in km (m) after
switching on the ignition.
CNG quality
Whenever you refuel the quality of the
natural gas is automatically verified
and is displayed when the ignition is
switched on. The display is made in a
percentage of between 70% and
100%. The greater the percentage dis-
played the lower the consumption may
be.
Average speed
The average speed will be shown after
a distance of about 100 metres has
been travelled. Otherwise horizontal
lines are displayed. The value shown is
updated approximately every 5 sec-
onds.
Digital display
of speed Current speed displayed in digital for-
mat.
Speed warn-
ing at --- km/h
or Speed
warning at ---
mph
If the stored speed is exceeded (be-
tween 30 - 250 km/h, or 19 -
155 mph), an audible warning is given
together with a visual warning.
Menu Function
Oil tempera-
ture
Updated engine oil temperature digital
display
Coolant tem-
perature
gauge
Digital display of the current tempera-
ture of the liquid coolant.
a)
In vehicles with a natural gas engine, range and average con-
sumption refer only to data or natural gas consumption. If you
are in “petrol mode”, the information of both data only appears
on the dash panel and not on the multifunction screen.
Storing a speed for the speed warning
● Select the display Speed warning at --- km/h
(--- mph)
● Press the button

on the windscreen
wiper lever or the button

on the multifunc-
tion steering wheel to store the current speed
and activate the warning.
● If necessary, adjust the desired speed with-
in 5 seconds using the rocker switch

on
the windscreen wiper lever or by turning the
thumbwheel on the multifunction steering
wheel. Next, press the button

or

again or wait several seconds. The speed is
stored and the warning activated.
● To deactivate it press the button

or
the button

. The stored speed is deleted.
Engine oil temperature display
Vehicles without multifunction steering
wheel
–
To view the temperature, press the rocker
button
›››
Fig. 87
2
until the main menu
comes up. Enter into Journey data . With the
button
2
move to the oil temperature
gauge.
Vehicles with multifunction steering wheel
–
To display the engine oil temperature, enter
the submenu
Journey data and turn the
thumbwheel until the oil temperature dis-
play appears.
The engine reaches its operating temperature
when in normal driving conditions, the oil
temperature is between
80°C (180°F) and
120°C (250°F)
. If the engine is required to
work hard and the outside temperature is
high, the engine oil temperature can in-
crease. This does not present any problems
as long as the warning lamps

›››

ta-
ble on page 23 or

›››

table on page 23
do not appear on the display.
Additional electrical appliances
3
Not available in vehicles equipped with natural
gas engine (CNG).
–
Operation with the windscreen wiper lev-
er*: Press the rocker switch
›››
Fig. 87
2
»
77
Tec
hnic
al s
pec
ific
ation
s
Adv
ic
e
Oper
ation
Saf
ety
The e
ssenti
al
s