10
SeaStar Hydraulic Steering
HYDRAULIC STEERING
KICKER CABLE TIEBAR
Figure 13. Cap Seal Installation.
Figure 14.
GOOD QUALITY
MARINE GREASE
HAND
TIGHTEN
STEP 12:
System Check
• Ensure the main steering cylinder (HC5345 or HC5358) can hit
hard over in BOTH directions.
• If steering cylinder HITS HARDOVER, in BOTH DIRECTIONS,
continue with points i. and ii. shown below.
If steering cylinder DOES NOT hit hard over in BOTH Directions,
consult with Trouble Shooting details shown on page 12
i Turn steering wheel from hard over to hard over. While turning,
visually watch for any signs of binding or interference with any
other object. If interference occurs it MUST be prevented prior
to use of the vessel.
ii Complete the above noted step in ALL trim/tilt ranges and
throughout the steering arc of the engine.
CAUTION
If the main steering cylinder is
NOT fully stroking out, in BOTH
directions, stop installation and
check for mechanical interference,
contact SeaStar Solutions
Technical Support.
CAUTION
If kicker engine is mounted on an
adjustable jack plate or bracket
you MUST inspect at ALL points
in UP/DOWN range.
