CONTENTS
Safety ...................................................................................2
Pump Performance/General Information ...........................3
Before You Start/Tools/Materials ........................................4
Installation
Piping ....................................................................4-5, 8-12
Electrical ........................................................................6-8
Helpful Hints.................................................................11-12
Parts ..............................................................................13-15
INTRODUCTION
Please take a few minutes to read our instructions before in-
stalling your submersible pump. It will help to assure per-
fect installation and help you avoid needless service
expenses.
Carefully read and follow all safety instructions in this man-
ual or on pump.
This is the safety alert symbol. When you see this sym-
bol on your pump or in this manual, look for one of
the following signal words and be alert to the potential for
personal injury!
warns about hazards that
will
cause serious
personal injury, death or major property damage if ignored.
warns about hazards that
can
cause serious
personal injury, death or major property damage if ignored.
warns about hazards that
will
or
can
cause
minor personal in jury or property damage if ignored.
The word
NOTICE
indicates special instructions which are
important but not related to hazards.
To avoid risk of serious bodily injury and property
damage, read safety instructions carefully before in-
stalling pump.
1.
Under certain conditions, submersible
pumps can develop extremely high pres-
sure. Install a pressure relief valve capable
of passing entire pump flow at 75 PSI (517kPa).
Do not allow pump, pressure tank, piping, or
any other system component containing water
to freeze. Freezing may damage system, leading to in-
jury or flooding. Allowing pump or system compo-
nents to freeze will void warranty.
2. Follow local and/or national plumbing and electrical
codes when installing pump.
3. Keep well covered while installing pump to prevent
leaves and other foreign material from falling into well,
contaminating the well and possibly damaging the pump.
4. Protect pump and piping system from freezing. Allowing
pump or water system to freeze could severely damage
pump and voids warranty.
5. To protect system against over-pressure, install a pressure
relief valve (Stock No. 27220).
6. With a new well, test well water for purity before using.
Consult your local Health Department for procedure.
Hazardous voltage. Can shock, burn,
cause death, or start fires.
7. Disconnect electrical power source before installing or
working on pump.
8. Use pump only in a well application.
9. Correct fusing, wiring and grounding are essential to
proper operation. See Page 6 for electrical instructions.
10. Line voltage and frequency listed on motor nameplate
must agree with line voltage and frequency of electrical
power supply.
11. Use of fuses or wire smaller than size recommended in
owner's manual can cause overheating, possible fires,
and will void warranty.
2
FULL ONE YEAR WARRANTY ON SUBMERSIBLE PUMPS
For one year from the date of purchase, when pump is installed and maintained according to our instructions and not subjected
to sand or abrasive damage, Sears will furnish and install a new pump, free of charge, if the pump is defective in materials or work-
manship. During the same period, Sears will repair the control center, free of charge, if defective in material or workmanship.
LIMITED WARRANTY ON SUBMERSIBLE PUMPS (NOT INCLUDING CONTROLS)
After one year and through three years from the date of purchase, Sears will furnish, free of charge, a replacement pump (not in-
cluding control center and fittings) if the pump is defective in material or workmanship. You pay for installation.
LIMITATION OF LIABILITY
SEARS WILL NOT BE LIABLE FOR LOSS OR DAMAGE TO PROPERTY OR ANY INCIDENTAL OR CONSEQUENTIAL LOSS OR EX-
PENSE FROM PROPERTY DAMAGE DUE DIRECTLY OR INDIRECTLY FROM THE USE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/DEPARTMENT IN THE
UNITED STATES.
This warranty applies only while the product is in the United States.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
RULES FOR SAFE INSTALLATION AND OPERATION
