32
© Sealevel Systems, Inc. eI/O Manual | SL9221 01/2023
If an eI/O module has been configured to DHCP mode, when you connect it to the network, the status LEDs
on the front of the module will blink while it searches for a DHCP server. Once it receives an IP address, the
status LEDs will remain on.
Now start MaxSSD (Start
All Programs
Sealevel Systems
SeaMAX
MaxSSD Configuration Utility)
and choose the correct IP address to communicate with the eI/O module. Ensure a successful Get
operation (refer to the MaxSSD section of this manual for more information).
RESETTING AN ETHERNET eI/O MODULE
An eI/O module may become no longer visible in the module list in the Ethernet Config utility if the eI/O
module has been configured to use a different subnet than the host computer.
In other cases, the eI/O module does not appear in the module list due to a DHCP discovery failure. In either
case, clicking on the “Recover Module” button (see image on previous page) in the Ethernet Config utility
will bring up the “Module Reset” window shown below.
