Sealer Sales CBS-880 I, Instruction Manual

Page: 13 / 45

C B S - 8 8 0 I N S T R U C T I O N M A N U A L
9
Figure 5. Two flower shaped knobs are found under conveyor.
2. Loosen the screw on the drive shaft and insert the conveyor middle post (found on the conveyor
table) to the drive shaft. Be sure the groove on the conveyor middle post lines up along the screw
on the drive shaft. Move the conveyor belt as needed to allow the conveyor middle post to meet
with the drive shaft. Once the conveyor middle post is in place, tighten the screw on the drive shaft
to lock the conveyor middle post in place.
Figure 6. Insert the conveyor middle post in drive shaft. Make sure
grooves are aligned.
Figure 7. Tighten the screw on the drive shaft to lock the conveyor middle post
in place.
3. Tighten the round nut (Figure 34, Item #18) along the drive shaft as well as the knobs and in front
of the band sealer (Figure 40, Item #12)
Operation Set-up
1. Our machines are equipped with a three-prong grounded plug. Make sure the plug is well-
connected in the socket to ensure safe operation.
2. Make sure the circuit breaker is in the “ON” position. (Levers pointing up)
3. First time operation. Allow the machine to pre-heat by running at a low temperature for a few
minutes. This would apply if the machine has not been in operation for a long time. The machine
can sometimes be damp from storage or shipment and running at a low temperature will dry out any
residual moisture.