Seakeeper 5500 GYRO, Installation Manual

Page: 32 / 66

INSTALLATION
MANUAL
Product: Document #: Rev: Page:
MODEL 5500 GYRO 90214 2 8 of 17
Section 2: ELECTRICAL INSTALLATION
2.3 Electrical Equipment Signal Connections
1. COMPACT MOTOR DRIVE BOX CABLES
a. Signal cables connect to the receptacles on the lower left side of the Compact Motor
Drive Box and come installed from the factory as shown in Figure 11. The ground cable
is also installed at the factory. The motor power connector comes from the factory
installed on the cable as shown in Figure 12.
i. J1: Motor Power, CABLE 10 from Gyro sphere.
ii. J2: Drive Control, CABLE 14 from Gyro Control Box.
iii. J3: Motor Instrumentation, CABLE 11 from Gyro sphere.
iv. Ground: Ground cable from stud to rear brace.
J1
Motor
Power
FIGURE 11 – COMPACT MOTOR DRIVE
BOX CONNECTORS (LEFT SIDE)
FIGURE 12 – COMPACT MOTOR DRIVE
BOX CONNECTORS (RIGHT SIDE)
Glycol
Cooling
Flow Out
Glycol
Cooling
Flow In
Circuit Breaker,
5 Amp, for
Seawater Pump
Output power
AC
POWER
IN
SEAWATER
PUMP POWER
OUT
J3 MOTOR
INSTRUMENTATION
J2 DRIVE
CONTROL
GROUND
CABLE