Seakeeper 5500 GYRO, Installation Manual

Page: 28 / 66

INSTALLATION
MANUAL
Product: Document #: Rev: Page:
MODEL 5500 GYRO 90214 2 4 of 17
Section 2: ELECTRICAL INSTALLATION
iv. The ground cable for the Compact Motor Drive Box is installed at the factory as shown
in Figure 2.
3. COMPACT MOTOR DRIVE BOX AC POWER OUTPUT TO SEAWATER PUMP CONNECTION
INSTRUCTIONS
a. Cable: 3 x 16AWG (3 x 1.5mm
2
CSA) cable, 10’ (3m) length, Seakeeper supplied pre ‐
installed
b. Pumps rated at 230 VAC, 5 Amps max., Customer ‐ supplied.
i. Locate CABLE 8 for AC power output to the Seawater Pump from the Compact Motor
Drive Box at the smaller of two cable glands.
FIGURE 4 – COMPACT MOTOR DRIVE BOX AC POWER OUTPUT GLAND (Cable not shown)
Verify that AC power is OFF to the Compact Motor Drive
Box before connecting CABLE 8 to a Seawater Pump.
SMALL CABLE
GLAND FOR AC
POWER OUTPUT
TO CUSTOMER
SUPPLIED
SEAWATER PUMP