WWW.SEAGULLMODELS.COM
17
Slide the aluminum tube into fuselage.
Insert canopy hatch into fuselage as be-
low pictures.
ATTACHMENT WING- FUSELAGE.
Insert two wing panels as pictures below.
Use a clip to secure the wing to the fu-
selage.
Wing tube.
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED
60 to 66mm
BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
3) With the model upright, place your
fingers on the masking tape and carefully
lift the plane.
2) Mount the wing to the fuselage. Using
a couple of pieces of masking tape, place
them on the bottom side of the wing
60
to 66mm
back from the leading edge of
the wing at the wing root.
4) Do not turn plane upside down. Only
low wing models should be turned up-
sidedown for balancing. Remove this
paragraph, it is not intended for use in
the instructions. it is a note for you.High
Wing models must be balanced upright.
Summary of Contents for SEAX139
Page 19: ...WWW SEAGULLMODELS COM 19 ...
