SHOESTRING 25e EP
Instruction Manual.
16
6) Use a pin vise and drill bit to drill the
two locations for the control horn mount-
ing screws. The locations have been pre-
drilled at the factory.
8) Repeat above steps to connect the el-
evator pushrod wire. The positions and
measurements for the elevator connec-
tions are the same as the rudder.
7) Secure the control horn to the rudder
using two 2x12mm metal screws and a
control horn backplate.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
APPLY THE DECALS.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
Elevator pushrod.
Rudder pushrod.
2mm
Summary of Contents for SEAX139
Page 19: ...WWW SEAGULLMODELS COM 19 ...
