SPARROW HAWK
Instruction Manual
8
Install the spinner backplate, propeller and
spinner cone.(Spinner is not included).
INSTALLING THE SPINNER.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
3) Install the muffler and muffler extension
onto the engine and make the cut out in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve. Secure the cowl to fuse-
lage using the 3x15mm screws (4).
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
THROTTLE-ELEVETOR-RUDDER
SERVO INSTALLING.
Elevator servo.
Throttle Servo .
Rudder servo.
