www.seagullmodels.com
15
Covering strip.
INSTALLING HORIZONTAL FIN.
C/A glue.
Hinge.
Epoxy.
1) Remove the covering as same as
pictures shown below.
2) Sand the aluminium tube using
sandpaper. This will improve the bond of the
epoxy to the cardboard horizontal fin.
Coat both sides of one half of the aluminium
tube with 30 minute epoxy. Next, pour some
epoxy into the cardboard horizontal fin. Use
enough epoxy to fill any gaps.
3) Insert aluminium tube into the
cardboard of fuselage.
ELEVATOR - CONTROL HORN
INSTALLATION.
1) Install the elevator control horn using
the same method as with the aileron control
horns.
2) Position the elevator control horn on
the both side of elevator.
2 sets.
3x45mm.
Horizontal fin.
C/A glue.
Hinge.
4) Slide the two horizontal fin halves
together and carefully align them at the
possition on the fuselage. Wipe away any
excess epoxy using paper towels.
Elevator.
Epoxy.
Epoxy.
Epoxy.
Epoxy.
