FAIRCHILD PT-19
Instruction Manual
16
!
6) When you are sure that everything is
aligned correctly, mix up a generous amount of
Flash 30 Minute Epoxy. Apply a thin layer to the
mounting slot in the top of the fuselage and to
the sides and bottom of the vertical stabilizer
mounting area. Apply epoxy to the bottom and
top edges of the filler block and to the lower
hinge also. Set the stabilizer in place and re-
align. Double check all of your measurements
once more before the epoxy cures. Hold the
stabilizer in place with T-pins or masking tape
and remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the epoxy to
fully cure before proceeding.
!
5) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
CONTROL HORN INSTALLATION.
!
1) Locate the two nylon control horns, two
nylon control horn backplates and four
machine screws.
!
2) Position the elevator horn on the right
and left side of elevator. The clevis attach-
ment holes should be positioned over the hinge
line.
!
3) Using a 1.5mm drill bit and the control
horns as a guide, drill the mounting holes
through the elevator halves.
!
4)
Mount the control horns by inserting the
screws through the control horn bases and
eleva- tor halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
!
5) Position the rudder control horn on the
left side of the airplane. Mount the control horn
parallel with the horizontal stabilizer, not in-
line with the rudder hinge line.
Control Horn.
Mounting Screws.
Mounting Plate.
2mm X 20mm.
!
6) Install the rudder control horn using the
same method as with the elevator control
horns.
Epoxy glue.
