FAIRCHILD PT-19
Instruction Manual
10
Attach the silicone fuel, feed and pressure
pipe to the tank. The lower pipe is the ‘feed’
and the upper is the ‘pressure’ . The silicone
fuel pipe is the next of feed pipe.
!
5) With the stopper assembly in
place, the weighted pickup should rest away
from the rear of the tank and move freely in-
side the tank. The top of the vent tube should
rest just below the top of the tank. It should
not touch the top of the tank.
!
6) When satisfied with the align-
ment of the stopper assembly tighten the 3mm
x 20mm machine screw until the rubber stop-
INSTALLING THE STOPPER ASSEMBLY.
!
1) Using a modeling knife, carefully cut
off the rear portion of
one
of the 3 nylon tubes
leaving 1/2” protruding from the rear of the
stopper. This will be the fuel pick up tube.
!
2) Using a modeling knife, cut one
length of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and the
other end to the nylon pick up tube.
!
3) Carefully bend the second nylon tube
up at a 45º angle. This tube is the vent tube.
To set the angle of the vent tube use a lighter
or heat gun to heat the tube (do not melt the
tube).
FUEL TANK.
When the stopper assembly is installed
in the tank, the top of the vent tube should rest
just below the top surface of the tank. It should
not touch the top of the tank.
!
4) Test fit the stopper assembly into
the tank. It may be necessary to remove some
of the flashing around the tank opening using
a modeling knife. If flashing is present, make
sure none falls into the tank.
Vent tube.
Fuel Pick up Tube.
Fuel fill Tube.
INSTALLING THE ENGINE MOUNT.
See pictures below:
M4 machine
screw.
4x20mm.
