FAIRCHILD PT-19
Instruction Manual
17
ELEVATOR - RUDDER PUSHROD INSTALLATION.
Elevator control horn.
Right side.
Pushrod.
Clevis.
Elevator
Pushrod.
Rudder
pushrod.
!
3) While holding the clasp firmly in place,
use a pen and outline the clasp onto the rud-
der.
!
4) Remove the clasp, and using a mod-
eling knife, remove the covering from inside
the lines you drew. Use 220 grit sandpaper
and carefully roughen the inside surface of the
nylon clasp.
!
5) Slide the clasp back into position and
carefully glue it into place using Kwik Bond Thin
C/A. Hold the clasp in place until the glue com-
pletely cures. Secure by 1 machine screw.
!
2) Using a ruler and a pen place a mark
onto the bottom of the rudder. The back edge
of the clasp should line up with this mark.You
may find it necessary to bend the tail wheel
wire down slightly so it lines up with the clasp
without binding.
!
1) Align the tail wheel wire so that the wire
is parallel with the bottom of the rudder. The
control clasp has a predrilled hole through the
top of it. Slide this hole onto the tail wheel wire
while sliding the clasp over the bottom of the
rudder.
MOUNTING THE CONTROL CLASP.
Control clasp.
2x20mm.
Machine Screw
Elevator control
horn both side.
Rudder control horn.
Elevator control horn.
Left side.
