FAIRCHILD PT-19
Instruction Manual
11
Slide the tank into the fuselage from inside
so that the neck is at the top of the fuselage
and it locates through the engine bulkhead.
Gently secure it to the top horizontal former
with the cable tie .
MOUNTING THE ENGINE.
PARTS REQUIRED
!
1) Install the pushrod housing through
the predrilled hole in the firewall and into the
servo compartment. The pushrod housing
should protrude 1/4" out past the front of the
firewall. Make a Z-Bend 1/4" from one end of
the plain wire pushrod.
Vent tube.
Fuel fill
Tube.
Fuel Pick up
Tube.
Fuel Tank.
3 x 25mm.
!
2) Bolt the engine to the engine
mount using the four machine screws.
Double cheek that all the screws are tight
before proceeding.
Pushrod wire.
115mm.
!
3) Attach the Z-Bend in the pushrod
wire to the throttle arm on the carburetor. You
will need to remove the throttle arm from the
car- buretor to be able to attach the Z-bend.
When complete, reattach the throttle arm to
the car- buretor.
Blow through one of the lines to en-
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should flow through easily.
You should mark which tube is the
vent and which is the fuel pickup
when you
attach fuel tubing to the tubes in the
stopper. Once the tank is installed inside
the fuselage, it may be difficult to determine
each of them.
