Internal SCSI Minicartridge Drive
Page 8
Installation Manual
Terminator Power Enabled
Terminator power (+5-volt) is enabled by default.
!
Caution:
If the jumper is installed, be careful
not to short the TERMPWR signal to ground.
The drive contains a terminator power fuse to prevent
damage to drive components in case the terminator power
is shorted. If terminator power is enabled and the SCSI
cable is connected upside down for example, this fuse may
blow to prevent damage to the drive itself. In that case,
return the drive to an authorized repair facility.
Mounting the Drive Unit
The internal drive can be installed in a one-inch high by
3.5-inch form factor or in a half-high by 5.25-inch form
factor (with rails). The drive can be installed in three
different orientations: one horizontally (LED to the left)
and two vertically (LED up and down).
The following section provides directions for mounting the
drive in either a 3.5-inch enclosure or in a 5.25-inch
enclosure.
Installing the Drive
The following steps guide you through installing the
internal drive.
!
Caution:
Turn off your computer before you
begin the installation. Failure to do so might
result in damage to your equipment or electrical
shock to you.
Note:
Because computer models vary between
manufacturers, refer to your computer manual for
specific installation instructions.
