Internal SCSI Minicartridge Drives
Installation Manual
Page 11
rear of the unit. When you make the connection, be
sure pin 1 of the connector aligns with pin 1 on the
SCSI connector.
Note:
Pin 1 on the SCSI connector is to your right as
you look at the back of the drive. (See Figure 3.)
Your SCSI cable should have Pin 1 highlighted by a
color strip. Be sure to mate Pin 1 on the cable to Pin
1 on the drive. Failure to do so could make the drive
inoperative.
10. Replace the computer cover and reconnect any
peripherals that you disconnected during the
installation.
11. Plug the computer and any peripherals into an AC
power outlet.
Using the Drive
The drive is simple to operate. The following information
briefly explains drive operation.
Front Panel LED Operation
The front panel of the Travan drive contains the cartridge
opening and one round, green light emitting diode (LED).
This LED is lit when the tape is NOT at the beginning of
the tape. Thus, the LED shows tape movement when lit.
Figure 7 shows the front panel of the drive.
