Internal SCSI Minicartridge Drives
Installation Manual
Page 9
1.
Write down the serial number and model number
shown on the drive and put this information in a safe
place. You need this information if you ever call for
service.
2.
Refer to the manual that you received with your
computer for instructions about removing the
computer cover and the face plate from the drive bay
in which you plan to install the drive.
Note:
If devices are installed in any drive bays
adjacent to the one you are using for the internal
drive, partially removing those devices might give
you more working space.
3.
Check that jumper settings and termination are
correct for your installation. (Refer to the previous
text under
Configuring the Drive
.)
4.
Attach any special mounting hardware to the drive
that your system might require. Refer to the
manual that you received with your computer for
requirements.
5.
Locate the mounting screw holes in the drive
brackets. Each side contains two sets of holes. Use
the set that aligns the drive properly within the
drive bay.
6.
Slide the tape drive into the computer so that the
drive bezel and the computer face plate are flush.
Then, align the mounting holes as shown in
Figure 6.
