______________________________________________________
WTS32 Wireless Thermostat
950-0160revB February 2, 2012
30
IMPORTANT!
– If using a Heat Pump System with fossil fuel as AUX Heat, an external fossil fuel kit or outdoor sensor
must be installed and CONFIGURATION STEP 11 (STAGES) must be set to CO. The AUX will be activated when the
room temperature reaches 3˚F or ˚C below set point if SPAN1, SPAN2 and SPAN3 are set to 1˚F or ˚C. If the set
temperature is satisfied and there is a call for He
at within compressor delay, the “Wait” icon will appear.
Step 12) Factory default is
“ ”.
PROG sets function of thermostat to Programmable ( ) or Non-Programmable ( ). Programmable mode allows all the
programming functions normally available for the thermostat while Non-Programmable allows HEAT, COOL, AUTO, EMER and
temperature set point to be selected only. Thermostat will keep room temperature at set point until changed.
Step 13) Factory default is
“ ”.
The
mode is used to set the thermostat (transmitter) and receiver (controller) to match channels. If the building has more
than 100 Sea Breeze wireless systems, it may be necessary to select another channel. Select the next channel and press the
receiver Match button to re-match the transmitter and receiver.
Step 14) Factory default is
“ ”.
Select “ ” to Match transmitter to receiver.
The "
" is used to set up the communications between the transmitter and receiver. This step must be performed to have
the receiver communicate with transmitter.
Step 15) Factory default is
“ ”.
Selections to lock key pad security. = Allows temperature selection only.
= All key pad functions are locked.
