OWNER
’
S MANUAL
(
SEA ISUZU FSR/FSD EV)
SEA-OWS-QA-004/5
ISSUE DATE:
30/05/2020
Page
47
of
56
After the charging process
completed (fully charged 100%),
the both LED's at the vehicle
side socket will turn to Unlit in 5-
10 seconds.
LEDs are deactivated to
prevent drain on low
voltage system.
11
Confirm that the right LED
found at the vehicle side socket
lights up Flashing Green. This
shows that the charging process
in now underway.
C
h
ar
gi
n
g
P
ro
ce
ss
13
10
Remove the cap and plug the
charging connector (Vehicle-side
socket) to the charging inlet.
This will lock automatically.
Phase
Step
Safe Operating Procedure
Note
Photo
Instruction
8
Once powered ON, check the
EVSE is operational by
confirming set to 32 amperes.
9
Open the charging inlet flap on
the component box.
Located at the component box
found on the side of the vehicle.
On opening the vehicle
charging cap, look for dirt,
debris and foreign objects.
Clean before connection if
needed.
NOTE: Charger on the truck
component box is never
live, just for power input
and will not output power.
The vehicle side socket will
light up White on the left
LED for 1-2 seconds before
it turns Flashing Green to
indicate charging has
commenced.
SEA-Drive® Charging Procedure (Two-LED Function)
SOP NO.
SOP-SD-006
Rev
0
Page
2/ 4
Model
SEA-Drive®
Variation
AS/NZ Trucks
Issue Date
Apr 2020
12
Once the charging cycle has
been completed and the battery
is fully charged (100%), the right
LED at the vehicle side socket
will turn to solid GREEN.
Once full charge is reached,
the SEA Drive system
automatically shuts down
to stop any residual load
on the battery system.
