English
GATE 1 DG R1
67410182
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
C S
N
CNS
RADIO TRANSMITTER SELF LEARNING
WITH RF FIX RECEIVER ON BOARD OF CONTROL UNIT
!!
WARNING: Make the radio transmitters programming before you connect the antenna and insert the receiver
into the special CNS connector (if available) with turned off control unit.
With the RF FIX module it will be possible to use only the transmitters with fixed code.
Select through the display
trans itters
and press OK, now select with the UP and DOWN buttons, the command to which you
want to associate the button (it is possible to associate max. 2 commands) and press OK to confirm the choice, now press the
button of the radio transmitter which you want to associate. If the storage is successful, the display will show
STORED
.
In the
trans itters
MENU it is possible to select
Start
(to associate a Start command),
pedestrian start
(Pedestrian Start),
external odvle
(
StoP
(To associate the STOP command to the TX),
vnlo(k
(to associate the release of the electric brake to the transmitter),
dELete a trans itter
(To delet the single transmitter only if it is
a Rolling Code Plus),
(lear e ory
(To delete all TX). To release the electric brake it is necessary to give three consecutive
pulses, the 4th will reactivate the lock of the electric brake.
Notes:
- Enter radio transmitters learning only when the working cycle stops and the gate is closed.
- It will be possible to memorize up to max. 16 codes (buttons).
- You can store max. 2 of the available 4 functions. If the control unit receives a code which was already associated to another
function it will be updated with the new function.
DELETE TRANSMITTERS FROM THE RECEIVER
With modules RF FIX, it will be possible to delete only the entire memory of the receiver.
Proceed as follows: select from the menu
trans itters: (lear e ory
and hold the OK button until the display shows the
message
Ok
.
For the activation of a contact on the EXP output),
U
U
U
U
U
U
U
U
U
Connect the receiver on
the CNS connectors,
making sure that the
direction is the
one shown in the
illustration.
35
Rev.06 - 09/2014
