Sea Pro 248, Owner'S Manual

Page: 38 / 50

38 248 BAY SERIES
RECOMMISSIONING AFTER WINTERIZATION OR STORAGE
After your SEA PRO boat has been winterized or put into
storage, it is necessary to perform proper steps to
prepare it for use and operation.
The following information is for general guidelines only.
Always refer to the manufacturer Owner
’ s Manuals for
specific instructions and information pertaining to those
systems and components.
It is always a good idea to consult your SEA PRO BOATS
approved dealer or a certified marine technician before
putting your vessel back into service.
•
Inspect the hull for any damage.
•
Inspect the battery cables and electrical wiring
for any loose connections.
• Check the bilge pump and free - float switch for
proper operation.
•
Inspect the fuel system for any leaks or damages.
•
Check the complete engine for any damage,
cracks, or leaks caused by freezing conditions.
• Check all hoses, clamps and valves for proper
fitting and operation.
•
Check all compartments and the bilge area for
any debris or nesting animals. Remove and clean
as necessary.
• Install drain plugs, Filters, and in - line strainers.
•
Install charged and properly maintained batteries.
•
Fill the fresh water tank and thoroughly flush
out all antifreeze solution from all connections
and outlets. Drain the system and sanitize the
tank and lines.
• Dilute 1/4 cup of household bleach for each
15 gallons of capacity into a gallon of
water. Add this solution to the fresh water
tank and fill with fresh water.
•
Let stand for three hours.
• Turn on the pump and completely drain the
fresh water tank and all connections and
lines.
•
Fill the fresh water tank with clean fresh
water, and let stand for an additional two
to three hours.
• Turn on the pump and completely drain the
fresh water tank and all connections and
lines.
•
If there is a smell of bleach remaining in the
compartment, perform and additional fresh
water rinse.
• Check and lubricate the Steering System.
•
Check all Navigation / Anchor lighting for proper
operation.
• Check fire extinguishers and all U.S. Coast Guard
required safety equipment for proper operation.
•
Check all controls, gauges, electronics and other
related equipment for proper operation.