54
36) Flushing Connector
(if so equipped)
A convenient connector is provided to
allow easy installation of a garden hose
to flush the cooling system.
Refer to POST-OPERATION CARE sec-
tion for proper use.
37) Bilge Drain Plugs
Should water be found in the bilge, it
can be easily drained by unscrewing
the drain plugs when engine is off and
watercraft is out of water.
CAUTION:
Remove boat from water
prior to unscrewing drain plugs.
TYPICAL
1. Drain plugs
1. Unscrew
2. Tighten
Tilt the watercraft slightly to the rear
so that the water can completely flow
out of the bilge.
It is suggested to drain bilge on a ramp.
CAUTION:
Make sure drain plugs are
properly secured prior to launching
the
watercraft
in water.
38) Automatic Bilge Pump
(if so equipped)
Bilge pump evacuates water from the
bilge.
When safety lanyard cap is installed on
its post, bilge pump automatically
turns on. It will remain on until all water
is evacuated, if any, then it will shut
down automatically.
When engine is running, bilge pump
will automatically start periodically to
evacuate water.
39) Jet Pump Nozzle
Jet pump nozzle turns side to side via
rider input at the handlebar. This pro-
vides directional control when engine
is running.
40) Reverse Gate
(if so equipped)
When selecting the neutral or reverse
position with the shift lever, the re-
verse gate moves up or down to obtain
the desired position.
TYPICAL
1. Reverse gate
F17L0HZ
1
F02L2FY
1
2
1
F17L0HY
smo2002-002a.book Page 54 Monday, July 30, 2001 2:18 PM
www.SeaDooManuals.net
Summary of Contents for GS 2002
Page 1: ...www SeaDooManuals net ...
Page 132: ...www SeaDooManuals net ...