Sea-doo 1997 GSI, Shop Manual

Page: 161 / 372

Section 07 ELECTRICAL SYSTEM
Sub-Section 02 (IGNITION SYSTEM)
07-02-7
1. Timing light pick-up
3. Start engine and point timing light straight in
line with timing tool slot. Bring engine to the
specified RPM as per following table:
1. Timing light straight in line with tool slot
4. Check if PTO flywheel mark aligns with timing
tool slot.
NOTE: On this system, timing advance decreas-
es as engine speed increases.
If timing mark aligns with tool slot, timing is prop-
erly set. If not, refer to
Ignition Timing Adjust-
ment in this sub-section.
787 Engine
1. Connect an induction-type tachometer (P/N
295 000 100) to spark plug wire.
1. Tachometer pick-up
2. Connect timing light pick-up to MAG side spark
plug wire.
1. Timing light pick-up
3. Rev the engine to 3500 RPM and point beam of
timing light straight in line with timing mark
pointer.
ENGINE RPM
717D 5500
717 6000
-
CAUTION
If engine is to be run more than a few sec-
onds, engine must be cooled using the flush
kit.
F00H0HA
1
F00H0IA
1
F06H06A
1
F00H0HA
1
www.SeaDooManuals.net