Sea-Bird Electronics SBE 45 MicroTSG, User Manual

Page: 54 / 143

Appendix III: Command Summary SBE 45
46
CATEGORY COMMAND DESCRIPTION
TS
Take sample, hold converted data in RAM, output
converted data
TSR
Take sample, hold raw data in RAM, output raw data.
SLT
Send converted data from last sample in RAM, then
take new sample and hold converted data in RAM.
TH
Take sample, hold converted data in RAM.
Polled
Sampling
Do not send these
commands if
MicroTSG is
sampling data at
pre-programmed
intervals.
SH
Send held converted data from RAM.
TT
Measure temperature 100 times or until Esc key is
pressed, output converted data.
TC
Measure conductivity 100 times or until Esc key is
pressed, output converted data.
TTR
Measure temperature 100 times or until Esc key is
pressed, output raw data
Testing
TCR
Measure conductivity 100 times or until Esc key is
pressed, output raw data.
DC
Display calibration coefficients; all coefficients and
dates listed below are included in display. Use
individual commands below to modify a particular
coefficient or date.
TCalDate=S
S= Temperature calibration date.
TA0=F
F= Temperature A0.
TA1=F
F= Temperature A1.
TA2=F
F= Temperature A2.
TA3=F
F= Temperature A3.
CCalDate=S
S= Conductivity calibration date.
CG=F
F= Conductivity G.
CH=F
F= Conductivity H.
CI=F
F= Conductivity I.
CJ=F
F= Conductivity J.
WBOTC=F
F= Conductivity wbotc.
CTCor=F
F= Conductivity ctcor.
Coefficients
(F=floating
point number;
S=string with
no spaces)
Dates shown
are when
calibrations
were
performed.
Calibration
coefficients are
initially factory-
set and should
agree with
Calibration
Certificates
shipped with
MicroTSGs.
CPCor=F
F= Conductivity cpcor.
51