«
THE REMOTE CONTROL » |
39
Using the Remote Control
The display’s IR sensor is embedded at the
center of the display behind the display
panel and cannot be relocated. When using
the remote control, aim the remote control
at the middle of the display’s front side
within a distance of less than 1.5m/4.9ft
from the IR sensor, and a horizontal and
vertical angle of less than 30 degrees.
NOTE:
Even when the remote control is pointed at the correct location where the IR
sensor is and within the correct range of the sensor, there is a chance that
environmental conditions may affect the proper functioning of the remote control.
If the remote control is not working, replace the batteries with new ones and make
sure that they are correctly inserted: Place two 1.5V AAA batteries matching the (+)
and (–) signs to the (+) and (–) indications of the battery compartment.
LOCKING/UNLOCKING THE REMOTE CONTROL
The IR sensor for the display can be locked so that the remote control function is disabled.
To lock the IR sensor/remote control:
1.
Press the [MENU] button on the remote control followed by [0], [0], and [2].
2.
Once the remote control is locked a lock icon will appear on the top-left corner of the display
indicating that the remote control has been locked.
NOTE: If the remote control has already been locked and the user try to use the remote
control, the lock icon will appear on the display again.
To unlock the IR sensor/remote control and enable the remote control function:
1.
Press the [MENU] button on the remote control followed by [0], [0], and [3].
2.
Once the remote control is unlocked the lock icon on the display will disappear indicating that
the remote control has been unlocked.
NOTE: The keypad will also be locked/unlocked when the IR sensor is locked/unlocked.
Use the OSD menu to lock/unlock only the remote control or the keypad. See the
“SETTING” section on page 43 for more information.
