16
| «
MOUNTING THE DISPLAY »
MOUNTING EQUIPMENT
CAUTION: This display cannot be used or installed without a support stand or a
mounting support accessory.
The display is designed for use with the VESA mounting system. When using mounting accessories
other than those that are approved by the dealer, they must comply with the VESA compatible
(FDMlv1) mounting method. It is recommended to use mounting interfaces that comply with
UL1678 standard in North America.
WALL MOUNTING
For proper installation it is strongly recommended to use a trained, qualified technician.
The back of the display is equipped with four screw-holes with dimensions of VESA mount 400 x
400mm (for 55”/75”) or VESA mount 400 x 600mm (for 65”). Firmly secure a wall mount onto the
display. Use four M6 screws on the 55” displays (maximum length: 20mm, maximum torque:
18 kgf-cm), four M8 screws on the 65” displays (maximum length: 20mm, maximum torque:
20 kgf-cm), and four M6 screws on the 75” displays (maximum length: 10mm, maximum torque:
18 kgf-cm).
NOTE: Refer to the proper installation instructions included with the mounting
equipment.
1.
Place the display face-down on a flat, padded surface for safe installation of mounting
accessories.
2.
For installation, it is recommended to use M6/M8 screws and tighten them securely. Screws
should have a Boss screw thread of at least 15mm (for 55”/65”) or 8mm (for 75”), a
loose-proof spring washer, and a length of 10mm (for 55”/65”) or 6mm (for 75”) longer than
the thickness of the mounting bracket.
55”/65”
75”
(Recommended Torque: <18 kgf.cm). Bracket hole should be under
φ
8.5mm.