scoole SC HT CL1 1000 WT, Instruction Manual

Page: 9 / 44

9
Electric convector
Уважаемый покупатель!
Благодарим Вас за удачный выбор и приобретение бытового электрического
обогревателя конвекционного типа
Scoole . Он прослужит Вам долго.
Connection to electric mains
1. The convector is designed for connection to 220V single-phase electric mains.
2. Prior to connection, make sure that parameters of the local electric mains meet the parameters
specified on the nameplate of the appliance.
3. During connection of the convector to the electric mains, it is necessary to observe the effective
electric safety rules.
4. The receptacle should be properly earthed. The receptacle should be designed for rated current
not less than 10A. The receptacle and plug should be always dry to avoid current leakage. Regularly
check that the plug tightly fits the receptacle as follows: a) insert the plug into the receptacle; b)
switch the convector off in half an hour of operation and remove the plug from the receptacle; c)
check by hand whether the plug is hot. If the plug temperature exceeds 50°C, the receptacle should
be replaced by a qualified specialist to avoid damage, accidents, or fire as a result of poor electric
contact.
WARNING !
The receptacle should be designed for rated current not less than 10A, while the electric cable should
have wire section not less than 3x1.5 mm (for copper).
²
7. Convector control
Convectors of SC HT С M1 series are equipped with a mechanical thermostat.
Convectors of SC HT CL1 series are equipped with a high-precision electronic thermostat with a
LED-display.
ENGLISH