Schwinn 425 Elliptical, Assembly Manual

Page: 30 / 34

30
TROUBLESHOOTING
Condition/Problem Things to Check Solution
No display/partial display/
unit will not turn on Check electrical (wall)
outlet Make sure unit is plugged into a functioning wall outlet.
Check connection at
front (recumbent) or rear
(upright) of unit Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
Check data cable integrity All wires in data cable (inside console mast) should be intact.
If any are visibly crimped or cut, replace cable.
Check data cable
connections/orientation Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check console display for
damage Check for visual sign that console display is cracked or
otherwise damaged. Replace Console if damaged.
Console Display If Console only has partial display and all connections are
fine, replace the Console.
If the above steps do not resolve the problem, contact Cus-
tomer Care for further assistance.
Unit operates but Contact
HR not displayed HR cable connection at
Console Be sure cable is connected securely to Console.
Sensor grip Be sure hands are centered on HR sensors. Hands must be
kept still with relatively equal pressure applied to each side.
Dry or calloused hands Sensors may have difficulty with dried out or calloused
hands. A conductive electrode cream such as “Signa
Crème” or “Buh-Bump” can help make better conduct.
These are available on the web or at medical or some larger
fitness stores.
Static Handlebar If tests reveal no other issues, the console handlebar assem-
bly should be replaced.
Console displays “E2” error
code
Check data cable integrity All wires in cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Console Electronics If tests reveal no other issues, Console should be replaced.
No speed/RPM reading, or
Console displays “E3” error
code
Check data cable integrity All wires in cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check magnet position
(requires shroud removal)
Magnet should be in place on pulley.
Check RPM Sensor
(requires shroud removal)
RPM sensor should be aligned with magnet and wiring
should be intact. Realign sensor if necessary. Replace if there
is any damage to the sensor or the connecting wire.