S
ervice Manual
Remote Control Cable/Radio
573
5.
S
afety Rules and Accident
Prevention Regulations
The safety rules and accident prevention regulations
contained in the machine’s operating instructions are
also applicable to the operation of the machine with the
radio remote control unit.
Some additional information is given below:
•
During the operation, the operator must have a
clear view of the machine and the concrete placing
site.
•
Do not place aside the transmitter as long as it
is ready for operation.
•
Always carry the transmitter in such a way that
any intentional contact with the control elements is
avoided.
•
Cut off the transmitter’s power supply during
interruptions of the work.
•
Always protect the transmitter against unau-
thorized use (by locking it away).
•
Before changing the control mode, set all con-
trol elements of the direct-, cable-, and radio-
remote units to the “0” position.
•
The transmitter is splash-proof (only when the
cover is closed), but not watertight.
The equipment may only be put into operation when
the cover of the receiver is properly closed.
Keep all parts clean and dry.
Close all unused connectors immediately with the
corresponding caps.
Keep the receiver cover closed when the machine is
being cleaned.
Avoid any contact of the equipment with steam jets and
aggressive detergents.
•
In case of trouble, never carry out repairs on
the equipment beyond those indicated in the trou-
bleshooting measures of the present operating
instructions, but rather inform the SCHWING
after-sales service.
•
Electric welding procedures always bear the
risk of damaging electronic components.
These components must be properly protected by an
expert in electronics before such work is carried out.
If the vehicle is to be retrofitted with a mobile car
telephone, the safe distance between the two antennas
must be at least 2 meters.
If this distance is not respected, telephone calls may
cause control signal transmission interference.
Home
