Maintenance and care
32
05.00 | KSF3, KSF3-LH, KSF3-F | TANDEM Clamping Force Block | en | 1467140
7.4.2 Basic cleaning
DANGER
Danger to life in case of improper disassembly. The cylinder
piston and the cover are under tremendous spring force, which
can eject the parts.
•
Any work requiring disassembly of the chuck piston, cover or
cylinder piston may only be performed by SCHUNK.
•
For basic cleaning, only the base jaws with their attachments,
as well as the chuck piston and the cover strip may be
dismantled.
For basic cleaning, the upper part of the product (base jaws with
attachments, cover strip and chuck piston) must be disassembled,
cleaned and reassembled.
With the "PM" variant, the pneumatic jaw end position control
must also be set.
Disassembly
Before disassembling the product, switch off the machine and
secure it against being switched on again. Then remove all
compressed air lines. No residual energy may be left in the
product.
• Pull out the plug (81).
• Unscrew the screws (84) and the fitting
screws (82) and disassemble the clamping
system from the machine table.
• If using clamping sleeves (85), remove them
from the housing.
