_________________________________________________________________________________________
schunk.com
XND.00015.012_A – 10/2018
23
4
Operation (standard operation)
4.1
Clamping / aligning
The basic version has step bores for screwing the KSX-C on the
T-slot tables with a pitch of 63 mm.
The KSX-C is fastened from the top with M12 cylinder screws.
For alignment on T-slot tables with 63 and 100 pitch, an
alignment and centering set is available as an accessory.
Alternatively, the KSX-C can also be clamped with clamping claws.
Attention:
Symmetrical distance of the two clamping claws is 100 to 150 mm
to the center of the vice.
The base plate is fitted with an interface to attaching the
clamping bolt for the VERO-S quick-change palleting system.
The KSX-C can also be produced at the factory with customer-specific positioning and fixing holes
as well as with location recesses for various commonly available zero point clamping systems.
4.2
Jaw range
The reliable function of the clamping device is significantly affected by the selection of the
correct jaws.
4.2.1
Fitting the system jaws
Please only use original cylinder screws (12.9).
The torque to be used for the cylinder screws is 105 Nm.
