SCHUNK CRT, Assembly And Operating Manual

Page: 25 / 36

Troubleshooting
7 Troubleshooting
7.1 Tool wears out or breaks
Possible cause Corrective action
Tool is not suitable for the
workpiece. Select the tool that matches the
properties of the workpiece.
Coat tool if necessary.
Too much material is being
removed. Check process parameters,
reduce infeed, reduce air
pressure for compensation,
perform machining in several
passes.,
Operation [
}
24].
The load on the tool is too great
because the product is moving
too slowly. Increase feed rate.
Compensation mechanism at
the stop. Readjust the offset,
Operation [ } 24].
High force on initial contact with
workpiece. Change the feed rate and/or
angle when approaching the
workpiece.
7.2 Tool rattles when deburring
Possible cause Corrective action
Feed rate not set correctly. Check process parameters,
reduce infeed, reduce air
pressure for compensation,
perform machining in several
passes.,
Operation [
}
24].
Compliance pressure too low.
Too much material is being
removed.
Tool is not suitable for the
workpiece. Select the tool that matches the
properties of the workpiece.
Tool is worn out. Change tool
7.3 Uneven deburring result
Possible cause Corrective action
The pressure valve is defective. Change pressure valve.
Ring cylinder assembly is
damaged.
Check ring cylinder assembly for
wear and replace if necessary,
Changing the ring cylinder
assembly
[
}
30]
25 02.00 | CRT | Assembly and Operating Manual | en | 1453513