Schulte FLX-1510, Operator'S Manual

Page: 52 / 150

ASSEMBLY
FLX-1510 06/18 Assembly Section 3-6
© 2018 Alamo Group Inc.
ASSEMBL
Y
Configure the FLEX-ARM for Use with a 10’ Rotary Cutter
The FLX-1510 can be configured for use with
either a 15 or 10 foot rotary cutter. As shipped, the
FLX-1510 is configured for use with a 15 foot
cutter. If the FLX-1510 is to be attached to a 10
foot cutter the "Castor Link" must be repositioned.
When the cutter is shipped the "Castor Link" is in
the position shown below.
• Remove pin "A"
• Move the "Castor Link" so the hole you
removed Pin "A" from is lined up with the hole
in lug "D"
• Remove bolt "B" (1" x 4") and spacer "C".
These items are found where the cutter hooks
to the rear of the FLX-1510. These are needed
to connect the "Castor Link" to Lug D.
• Take spacer "C" and insert it between the
Castor Link and lug "D" as shown below.
• Insert bolt "B" through the Castor Link, spacer
"C" and lug "D" and fasten all items together
using the 1" nut removed from bolt "B" earlier.