4
•
Service: Do not attempt to repair, modify or replace any part of the appliance unless specifically
recommended in this manual. Refer all other servicing to a qualified technician, or contact the sales
support line for advice on examination or repair of the appliance on
1300 376849 (Ext2)
, you can also
email on
Installation
•
Heavy: This appliance is heavy, take care when moving it. To avoid back or other injury, consider a
two person lift or mechanical aid when installing it. Failure to do so can result in back or other injury.
•
Freestanding design: This appliance is designed to be freestanding only and should not be recessed
or built in.
•
Keep it upright: Do not tilt the fridge more than 45º from upright when moving it.
•
Handle with care: Do not apply force to any part such as the condenser or door, don’t carry holding
door.
•
WARNING!
Ventilation: To ensure proper ventilation, keep any ventilation openings, in the
appliance enclosure or in the built-in structure, clear of obstructions. Ensure adequate air circulation
around the appliance to prevent overheating.
•
When positioning the appliance ensure the supply cord is not trapped or damaged.
•
Do not locate multiple portable socket outlets or portable power supplies at the rear of the
appliance.
•
Level: Install the appliance level in order to ensure proper operation. If necessary, adjust the
levelling legs at the bottom of the unit.
•
Location: Install the appliance in an area that meets the following requirements:
- The ambient temperatures must correspond to the climate class (T) indicated on the rating plate of the
appliance: 16°C to 43°C.
- The floor must be sturdy, level and strong enough to support the unit when fully loaded, avoid area’s
where the appliance would be exposed to direct sunlight, sources of heat, (stove, heater, radiator, etc.),
extreme cold ambient temperatures or excessive moisture and high humidity (such as outdoors or exposed
to wind, rain water spray or drips). Installing it in the coolest area of the room will the room will save
energy consumption and running costs.
•
When In Position: Allow 30minutes and turn “ON”.
Important
•
Store wine in sealed bottles
•
Do not overload the cabinet
•
Do not open the door unless necessary
•
Do not cover the shelving with aluminum foil or any other materials that may prevent air
circulation
•
Do Should the wine/beverage cooler be stored without use for long periods it is suggested, after
careful cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible
formations of condensation, mold or odors
Ambient room temperature
This appliance is designed to operate in ambient temperatures specified by its temperature class marked on
the rating plate.
Class
Symbol
Ambient Temperatures range(
℃
)
Extended Temperate
SN
﹢
10 to
﹢
32
Temperate
N
﹢
16 to
﹢
32
Subtropical
ST
﹢
16 to
﹢
38
Tropical
T
﹢
16 to
﹢
43
