6
Reverse the door (laying unit on back works best)
①Upper hinge ②Hinge shaft ③Hinge buckle ④Upper hinge ⑤Lower hinge ⑥Glass door
1. As shown in Figure 1, use a flat-
blade screwdriver to open the upper hinge buckle ③ to see the hinge
shaft ②, and then use a flat
-blade screwdriver to pry the hinge sha
ft ② and take it out. Then unscrew
the lower hinge in the same way.
2. As shown in Figure 2, the installation method of the upper part of the door is the same as the lower
part.
3. When the upper and lower parts are removed, pull the door parallel to the outside. The door can be
taken out.
4. Remove the glass door, use the hex wrench to remove the upper door hinge and the lower door hinge
mounting screws, and remove the upper and lower door hinges.
5. Pay special attention to this: 1) The glass door is turned 180 degrees to install, and the lock hook and
magnet of the door are removed and reinstalled to the other side.
2) The upper hinge and lower hinge are also exchanged at the same time. The right upper hinge is
changed into the left lower hinge. The right lower hinge is changed into the left upper hinge. Becomes
the lower door hinge, and becomes the upper door hinge when the right lower door hinge is changed to
the left side;
6. Install the door hinge first as shown in Figure 3, and install the lower door hinge as shown in Figure 4.
7. Lift the door as shown in Figure 4. Firstly insert the lower hinge into the corner fittings, align the
mounting holes, and insert the hinge shaft ② into the hinge hole in position. Then cover back the Hinge
buckle ③. The insta
llation of the lower part of the door is completed;
8. Install the upper part of the door as shown in Figure 3, the same method as the lower part of the
installation door. In the end the door revert is finished.
9. Install the door hinge Note: When installing the upper door hinge, please move the door hinge to the
side of the outer casing and then tighten the screw. After the lower door is installed, move the screw to
the inside of the outer casing and tighten the screw to prevent the door from falling.
