Clean your lock
In order to properly clean the touchscreen from build-up of
dirt, oils, or other contaminants; you should use a mild dish
soap with warm water and follow the general rules below:
•
Do
rinse the touchscreen with warm water prior to
cleaning process.
•
Do
follow the application of soap with a damp, lukewarm
cloth
•
Don’t
use abrasives, high alkaline cleaners, or gasoline
•
Don’t
leave cleaners on touchscreen for long periods,
wash immediately.
•
Don’t
apply cleaners in direct sunlight or at elevated
temperatures.
•
Don’t
use scrapers, squeegees or razors.
The bolt itself can be cleaned using a mild dish soap and
warm water. This can help improve decreased performance.
Warranty and FCC/IC Statement
Lifetime Limited Mechanical and Finish Warranty and 3-Year Limited Electronics Warranty
Subject to the terms and conditions of the warranty, Schlage extends a lifetime limited mechanical
and finish warranty and a three-year limited electronics warranty to the original consumer user
(“Original User”) of our Schlage brand product (“Product”) against defects in material and
workmanship, as long as the Original User occupies the residential premises upon which the Product
was originally installed. See
answers.schlage.com
for specific warranty details and limitations, or
contact Schlage Customer Service at (888) 805-9837 in the U.S. and Canada or (800) 506-7866 in
Mexico for assistance.
FCC/IC Statement
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
RF Exposure
To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this transmitter
should only be used or installed at locations where there is at least 20 cm separation distance
between the antenna and all persons. Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Conformément aux normes d’Industrie Canada, ce transmetteur radio ne peut fonctionner qu’avec
une antenne dont le type et le gain maxiumum sont approuvés par Industrie Canada. Pour réduire
les risques d’inteférences radio encourus par d’autres utilisateurs, le type et le gain de l’antenne
doivent être choisis de façon à ce que la puissance rayonnée isotrope équivalente (PIRE) ne soit pas
supérieure à celle nécessaire pour établir une bonne communication.
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject
to the following two conditions: 1) this device may not cause interference, and 2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme norme Industrie Canada RSS exempts de licence (s). Son fonctionnement
est soumis aux deux conditions suivantes: 1) cet appareil ne doit pas provoquer d’interférences, et
2) cet appareil doit accepter toute interférence, y compris les interférences pouvant provoquer un
fonctionnement indésirable de l’appareil.
Use of the HomeKit logo means that an electronic accessory has been designed to connect
specifically to iPod, iPhone, or iPad, respectively, and has been certified by the developer to meet
Apple performance standards. Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards. Please note that the use of this accessory with iPod,
iPhone, or iPad may affect wireless performance.
Apple, iPhone, iPad, iPad Air, and iPod touch are trademarks of Apple Inc., registered in the U.S. and
other countries. HomeKit is a trademark of Apple Inc.
