Check out the Interactive Instructions
For step-by-step, illustrated and video instructions, check out
the interactive instructions at the link below. Use any QR code
reader or type in the address into your web browser on any
internet-connected device.
https://instructions.allegion.
com/instr/65/1110
Prepare for Installation
Tools Needed
• Phillips screwdriver
• Tape Measure
• Pencil
For Alternate Faceplate
• Wood Block
• Hammer
IMPORTANT NOTES
DO NOT use a power drill for installation!
• Install and test lock with door open to avoid being locked
out.
Installation Instructions
A
Check door dimensions.
See
consumer.schlage.com/Service-Support
for door
preparation instructions if dimensions are different. If
crossbore is 1½", follow steps to remove spacer.
Also, check your door alignment. Make sure that the hole for
the bolt in the door edge lines up with the hole for the strike
in your door jamb.
2
³⁄₄
"
(70 mm)
OR
2
³⁄₈
"
(60 mm)
1
"
(25 mm)
Door Edge
2
¹⁄₈
"
(53 mm)
Crossbore
Hole
4
"
(100 mm)
Minimum
1
¹⁄₈
"
(29 mm)
2
³⁄₄
"
(70 mm)
1
"
(25 mm)
¹⁄₈
"
(3 mm)
Pilot Hole
¹⁄₈
" (3 mm)
3
"
(76 mm) Deep
1
¹⁄₂
" (38 mm)
1
"
(25 mm)
Deep
Strike Cut-Out (not to scale)
Rotate 180˚
if door stop is
on left side.
For maximum
security, install
reinforcement plate.
Actual Size
Actual Size
Door Stop
Only if crossbore is 1½” (Step A), Remove spacer.
Remove screw and remove spacer by rotating from the
outside touchscreen.
Reinstall screw then continue.
B
Install strike and reinforcement plate into door jamb.
Door jamb may need preparation to fit strike reinforcement
plate.
1
¹⁄₈
"
(29 mm)
2
³⁄₄
"
(70 mm)
1
"
(25 mm)
¹⁄₈
"
(3 mm)
Pilot Hole
¹⁄₈
" (3 mm)
3
"
(76 mm) Deep
1
¹⁄₂
" (38 mm)
1
"
(25 mm)
Deep
Strike Cut-Out (not to scale)
Rotate 180˚
if door stop is
on left side.
For maximum
security, install
reinforcement plate.
Actual Size
Actual Size
Door Stop
