Instruction Manual
Digital Electronic Combination Lock
Locking/Unlocking
To Unlock
1. Enter factory default passcode 1234 +
OK
or enter factory default Management Passcode 4321 +
OK
.
2. Long beep will sound.
3. Green indicator light will come on
4. Rotate the knob 90
°
within 3 seconds to open the lock. If the wrong passcode is entered, a beep will sound 3 times.
5. If lock shows red light this indicates low battery level.
NOTE: When entering Management Passcode to unlock, user passcode will be changed back to default 1234.
To Lock
1. Rotate the knob back to lock position.
1. Change passcode
1. Enter current User Pa
OK
, or Management Pa
OK
. Long beep will sound and will be
displayed.
2. Press
OK
for at least 2 seconds, then will flash.
3. Input new passcode, press
OK
. When you hear a long beep passcode has been changed.
NOTE:
Passcode can consist of 4-15 digits. Management Passcode and User Passcode can not be the same code.
2. Turn on public mode, set temporary password
1. Enter current Management Pa
OK
, a long beep will sound and Unlocking indicator light will be
displayed
2. Press
OK
for at least 2 seconds, Unlocking indicator light will flash. Press
OK
again.
3. Input “4 4” and press
OK
. When you hear a long beep public mode has been set.
‘Unlocked’ indicator light
KEYPAD
BATTERY COMPARTMENT
USB KEY INTERFACE
‘Low power’ indicator light
HOW TO OPERATE
Page 1
SETTINGS
Part No. 60129
