Scarlett SC-SI30K52, Instruction Manual

Page: 4 / 24

IM020
www.scarlett.ru SC-SI30K52 4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS

Please read the instruction manual before use and save it for future references.

Before the first switching on check that voltage indicated on the rating label corresponds to the mains voltage in your
home.

For home use only. Do not use for industrial purposes. Use the steam iron only for its intended use.

Do not use outdoors or in damp area.

Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.

Do not allow the cord to touch sharp edges and hot surfaces.

Always unplug the steam iron from the power supply when filling with water or emptying and when not in use.

To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If it has happened
DO NOT TOUCH the appliance, unplug it immediately and check in a service center.

In case of power cord is damaged, its replacement should be done by the manufacture or service department or the
other high-skill person to avoid any danger.

The appliance is not intended for use for physically, sensory or mental disabled person (including children) or for
person with lack of life experience or knowledge, if only they are under supervision or have been instructed about the
use of the unit by responsible person.

Children must be under control in order not to be allowed to play with the appliance.

Do not attempt to repair, adjust or replace any parts of the appliance. Check and repair the malfunctioning appliance in
the nearest service center only.

Do not leave the iron unattended while hot or connected or on an ironing board.

If ironing is interrupted, stand the iron on heel rest only, do not place the steam iron on metal or rough surfaces.

Iron should be used and stored on a flat, stable surface.

Iron should not be used if it is dropped, if there visible signs of damage or if it leaks.

CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperatur
e for at
least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless
such changes influence significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying documents in the following
format XX.XXXX where first two figures XX is the month of production, and following four figures XXXX is the year of
production.
IRON SOLEPLATE

The "Keramopro" soleplates are coated with the professional metal-ceramic coating developed in collaboration with
Scarlett specialists. The coating is characterized by an enhanced level of strength, glide and 100% resistance to
burning.
BEFORE THE FIRST USE

The device is designed for Ironing clothes and other fabric products.

Some parts of the steam iron have been slightly greased and as a result the iron may slightly smoke when switched on
for the first time. After a short time this will cease.
HOW TO USE
SETTING TEMPERATURE

Always check whether a label with ironing instructions is attached to an article to be ironed. Follow these instructions in
all cases.

Turn the temperature control dial round to set the appropriate temperature indicated in ironing instructions or on fabric
label.
LABEL TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester, Rayon
••
Wool, Silk
•••
Cotton, Linen
Maximum temperature (Steam)

Insert the mains plug into the wall socket. The indicator light will turn on.

When the indicator light goes out you may start ironing

If you set the temperature control to lower setting after ironing at a high temperature, it is not recommended to iron
before the pilot light switches on again.
WATER TANK FILLING

Unplug the iron before filling the water tank.

Hold the steam iron in horizontal position.

Slowly pour water through the water inlet.

Do not fill higher than mark on the water tank, in order to avoid water spilling.
NOTE: Your steam iron is designed to use tap water. However, if the water is very hard, it is advisable to use distilled
water.

The opening which is used for pouring water should be closed when the iron is in use.

Always unplug the iron from the power socket when refilling the water reservoir.

Do not use chemically de-limed or perfumed water.