Installation
ScanMate F6 / ScanMate F8 Plus • Operator’s Manual
2•5
6 • Connect the scanner to the wall outlet.
7 • Turn on the SCSI units, including the scanner, and turn on the computer.
SCSI CONNECTION TROUBLESHOOTING
If there are problems with the computer system when more than one SCSI
unit is attached, check the following:
• All units must be turned off when cables are connected or disconnected.
• Two units must not be given the same SCSI address.
• The total length of the SCSI cables should be kept as short as possible.
As a guide, the maximum length should be approximately 1.5 meters
(5 feet).
• A terminator must be placed on the last SCSI unit in the chain. This is
especially important with a Macintosh Quadra or Power Mac.
• Some SCSI units have a built-in terminator. Such a unit must be placed
last in the SCSI chain, or the terminator must be removed by the supplier.
The ScanMate F6 and ScanMate F8 Plus are not internally terminated.
• If your SCSI units still cause difficulties, connect one unit at a time until
you find the unit that is causing the trouble.
Calibrating the scanner
Before you start to use the scanner, it must be white-point calibrated and
focus calibrated. Please see “Scanner Calibration and Focus Adjustment” in
the
ColorTrio Operator’s Manual
.
Summary of Contents for ScanmateF6
